Member Attendance: Pietro, Anthony, Trung, Nick, Shane, Zach
This meeting we discussed how we are going to specifically mount the the sonic sensors up to the hat. Some problems were raised though. The geometry of the cap proved to be difficult to work with the sonic sensors. When we tried different positions on how users might want to wear the hat and concluded that there was too much lee way on how the sensors can be mounted at different angles. To remedy this we decided to place something rigid in between the hat and each sensor to keep them in place.
Below is our new circuit design. The 3 top sonic sensors will be mounted to the front of the hat and the 2 at the bottom will be mounted at the back. The power buttons to the right control the whole device, the front sensors, and the back senors from top to bottom. All of the sonic sensors are connected to the Arduino board which is connected to a board with all the haptic sensors (in the middle) controlling all the vibrations.
 |
| This is the new circuit design for S.A.V.E. |
